Brake Bias

I just found this link…

Not sure how it works but I’m sure someone here can explain.

Well if you read it states that adjusts the brake bias for the rear.

Essentially that knob only allows so much presure to reach the rear brakes. So when you press on the brake 0% - 100% brake pressure is applied.

This is something someone might use in autocross or rally racing because you may not the rears to slow the car down as fast as the front.

Actually I was advised to do this when doing the rear brake swap by a couple of knowledgable gear heads. This is because rear discs require a different amount of pressure to be applied to function properly.

change the proportioning valve does the same effect…

Does your kit include instructions how to do that? Might be a neat selling point for the kit, just saying.

yes we include all instructions